KoomBook assembly
Français
English
1.
The KoomBook
2.
KoomBook Components
3.
Tools Needed
4.
Important Reminders Before You Start
5.
Plastic Case KoomBook
Attach the Hard Drive
Attach 4 15-mm Standoffs to the F1 Deck
Attach 4 20-mm Standoffs onto the F2 Deck
Attach the F1 and F2 Decks
Connect the SATA Cables and Power Cables to the Hard Drive
Attach the Heat Dissipater to the Processor
Tin Your Electrical Cables
Weld 1 Wire to the Olimex Card
Weld 2 Wires onto the Olimex Card
Fasten the Olimex Card to the F2 deck
Fasten F1 Deck to the Case
Fasten the Switch to the Front of the Case
Weld Wires to the Switch
Weld the Micro USB Socket
Connect the SATA Cables and Power Cables to the Olimex Card
Attach the Micro USB Socket
Insert the LiPo battery
Attach the Ethernet Connector
Connect the Cables
Finalize the Assembly
6.
Wooden Case KoomBook
Attach the Hard Drive
Attach 4 15-mm Standoffs to the F1 Deck
Attach 4 20-mm Standoffs to the F2 Deck
Fasten 2 15-mm standoffs onto the F2 deck
Attach the F1 and F2 Decks
Connect the SATA Cables and Power Cables to the Hard Drive
Attach the Heat Dissipater to the Processor
Tin Your Electrical Cables
Weld 1 Wire to the Olimex Card
Weld 2 Wires onto the Olimex Card
Fasten the Olimex Card to the F2 deck
Connect the SATA Cables and Power Cables to the Olimex Card
Fasten the Switch to the Front Side of the Case
Weld the Switch
Weld the Micro USB Socket
Connect USB and Ethernet Cables to Back of the Case
Assemble the Case
Connect the Cables
Finalize the Assembly
7.
The KoomBook with Raspberry Pi
Components of the Raspberry Pi KoomBook
Clear History
Export to PDF
Publié par
Bibliothèques Sans Frontières
Built with
Grav
- The Modern Flat File CMS
Edit this Page
Finalize the Assembly
Equipment Needed
KoomBook case
Case top
4 metal screws
Assembly
Put the lid on the case, and screw it in. Then put the yellow pads on each side of the case. Congratulations, you have successfully set up the KoomBook!
